Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 31, No. 4 (2007)

Philip G. Lumley

Individual tip 2 of 2 from this reader’s published contribution.
Philip G. Lumley, Wilkesport, Ontario

“I didn’t want to risk climbing a ladder to clean the 30-ft. high chimney on our house so I built a chimney sweep that lets me clean the chimney by simply turning a crank at ground level. I installed a square metal frame over the top of the chimney with a small pulley fastened to it. A stainless steel cable runs from a spool attached to the crank and is attached to a 10-in. wide brush that has a 15-lb. weight attached to it. The crank extends through a small hole that I cut into the bottom of the chimney. When I turn the crank one way it winds the brush all the way to the top. Then I turn the crank the other way to let the brush back down. It takes 16 turns of the crank to completely clean out the chimney.

“Whenever I’m not using the brush it stays at the bottom of the chimney below the inlet where my stove pipe goes into the cleanout area.

“I used 2-in. angle iron to make the frame and set it right on top of the brick chimney. I use a pair of threaded rods, one on each side, to hold the frame tight to the brick.

“Now it’s an easy job to clean the chim-ney whenever I want. It takes only 5 or 10 minutes to clean it out.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.