“I was putting an old Deere 420C tracked tractor back into working condition. The guide flanges on the front idler wheels were so worn the tracks kept coming off. To remedy the problem without spending a lot of money, I measured the gap between the guide flange and the chain on the track. I then divided the measurement by two and bought some hot roll flat steel the thickness of half the gap and as high as the flange. I measured the circumference of the idler wheel and cut four pieces to this length. I then welded a piece of the flat on edge along the flange, welding about 1/2 in. up along the side, then used a 3-lb. hammer to bend the flat around the wheel as I kept welding it down about 1/2 in. at a time. The heat softened the flat steel as I went. I welded to both sides of the flanges on both wheels. The idler wheels are weld-able cast so ordinary welding rod works nicely. Haven’t thrown a track since making the modification.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.