Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 34, No. 2 (2010)

Brake Rotor Makes Great Base For “Third Hand”

Featured source:

With a little ingenuity and some scrap steel, Mike Erdelen of St. Charles, Mo., made a handy and inexpensive “third hand” work support for his auto repair shop. His idea can be adapted to practically any shop. The unit consists of a larger pipe welded to a brake rotor that serves as a base and a smaller pipe that telescopes in and out and is welded to a U-shaped plate that supports the work. To hold the tool at the correct height, Erdelen welded a 3/8-in. hex nut over a 1⁄2-in. dia. hole drilled near the top of the base pipe. A 3/8 by 2-in. bolt threads into the nut to act as a set screw. To make the set screw easy to tighten by hand, he welded a short rod across the head of the bolt. Depending on your needs, you could build a tall “third hand” like the one shown in the photo, or scale it down to hold work at any comfortable height.

“I like this unit because it doesn’t have a large tripod base like commercial units,” says Erdelen.

“It’s a lot easier to work around this one.” Contact: FARM SHOW Followup, Mike Erdelen, Fred’s Car Care, 1130 First Capitol Dr., St. Charles, Mo. 63301 (ph 636 946-1446).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.