Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 36, No. 5 (2012)

Easy Way To Change Broken Teeth On Wheel Rakes

Featured source:

“This photos show how I can change the broken teeth on my wheel hay rake. The clamps free up my hands to replace the teeth, as well as to replace the brackets and bolts,” says Jim Brashears, Olathe, Kan.

“I start by cutting four 1 by 2’s about 6 in. long. I put a block on either side of the good teeth, in front of and behind the bad tooth. Then I use 4-in. C-clamps to tighten the blocks against the teeth, positioned under the last ring on the wheel.

“This idea is really handy and saves a lot of time, because I don’t have to fight several teeth for alignment with one hand while putting the brackets and bolts together with the other.” Contact: FARM SHOW Followup, Jim Brashears, 11035 S. Waverly St., Olathe, Kan. 66061 (ph 913 909-1347; [email protected]).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.