Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 42, No. 1 (2018)

Doug Clark

Doug Clark, Ilderton, Ontario

“I was reading my copy of your “Great Shop Ideas – Volume III” and came across an idea from a fellow who suggested adding a couple gallons of gas to the fuel tank of a worn-out diesel engine to reduce smoke and misfiring.

“I think almost any mechanic would agree that there is almost always a good solution to problems with old engines that does not include gasoline. After millions of revolutions, the cogs on timing gears tend to wear enough to slow down injection timing. Late fuel injection causes poor starting, lack of power, and excess smoke. Injector pumps are normally mounted on 3 studs and have elongated curved slots that enable simple timing adjustment. Just loosen the 3 nuts on the pump mounting flange, start the engine at idle, and slowly turn the pump forward 2 to 3 degrees. At idle the engine will speed up a little as you advance the timing. Then check the engine under load at higher rpm’s. It should smoke less, produce more torque, and stop misfiring.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.