Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 43, No. 2 (2019)

Roll-Around Shop Crane Converted To 3-Pt. Model

Featured source: Ethan Rice

Ethan Rice, Spring Hill, Kansas, converted a Harbor Freight floor shop crane to a 3-pt. mounted crane.

“That makes it easy to use outside the shop, when needed. I left the crane’s wheels in place so when the unit is detached, I can still roll it around on a cement floor,” says Rice.

“The crane came with tiny cast iron caster wheels, and if I needed to use it on dirt or gravel it wasn’t very handy. I paid only about $100 for the crane. It comes in handy to pick up tote boxes, logs, big rocks, and other heavy objects.” He welded a length of 4-in. channel iron vertically to the base of the crane that runs all the way to the top, then welded on short lengths of channel iron to form a 3-pt. hitch.

“I borrowed the idea from a neighbor and like how it turned out,” says Rice.

“I originally built it to lift a Jeep Cherokee by the front cross member and set it off to the side so I could replace the front axle. The tractor’s 3-pt. cylinders have a lot more lifting power than the cylinder on the crane’s original hand-operated jack, so any time I use the crane to lift something heavy I first pump the jack a couple of times with the load on to make sure I don’t overload the crane and accidentally bend it.” Contact: FARM SHOW Followup, Ethan Rice, 21685 Oakcrest Rd., Spring Hill, Kansas 66083 (ph 913 731-5084; [email protected]).

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.