“My 10-year-old Work Sharp knife sharpener does an excellent job (www.worksharptools.com; ph 800 597-6170). I can use it with 3 different sanding belts - an 80-grit to shape the blade and remove any knicks; a 220-grit to put a nice edge on the blade; and a very fine 6,000-grit to polish the blade edge. It works so well that I could probably get a knife sharp enough to shave with it.
“It was definitely worth the $75 I paid for it. My only complaint was that I could only sharpen one side of the blade at a time, which prompted me to build my own sharpener that sharpens both sides using 2 sets of sanding belts.” Boehler made the double-sided sharpener by using the electric motor and main bearing shaft and pulley off an old Sears Craftsman belt sander. The entire assembly sets on a rectangular steel plate, with the motor mounted on an 8 1/2-in. length of 2-in. square tubing attached to the plate. A pair of spring-loaded clamps are used to adjust belt tension.
“I had acquired a supply of small electric motor bearings in various lengths, and used various sizes of aluminum shaft to make shafts and pulleys,” says Boehler.
“I bought O-ring drive belts at a NAPA store and mounted them on grooves that I cut into the shafts. It’s designed to use the same sanding belts that Work Sharp uses on its sharpener.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.