Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 46, No. 6 (2022)

Ready Davis

Ready Davis, Bigfoot Equipment & Repair, Willow Creek, Calif.

“As a Husqvarna dealer I feel I should respond to recent readers who have had issues starting their 562XP chainsaws. I understand their frustration. The manual is less than clear and the ‘universal’ symbols on the starting decal are virtually unintelligible. I’m guessing their dealer was not too clear when explaining the new control switch design.

“To start, pump the push bulb a few times to prefill the hose and carb with fresh fuel. Next, grab the red control lever and pull it straight out and up before releasing it in the locked ‘choke’ position. Pull the rip cord until the engine pops or you hit four pulls. Then put the control lever in the ‘run’ position. Don’t touch the trigger yet. Pull the cord once or twice and your saw should start and be running at high throttle until the trigger is pressed, which will release the throttle lock.

“Push down on the control lever to stop. Air-cooled engines tend to heat up after being turned off, which can sometimes make them hard to restart. For a reliable restart, pump the fuel bulb four to six times to push overheated fuel out of the cab and replace it with cooler fuel from the tank. Then raise the control lever to the choke position before lowering it right back down to the run position. This will set the throttle lock until the trigger is touched again. One or two pulls should start the saw right up again.

“I have sold and serviced more than 100 of these chainsaws and would not continue to do so if I felt that the saw had inherent flaws.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.