Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW
Home / Vol. 47, No. 3 (2023)

S. Brooke Adams

S. Brooke Adams, Sullivan, N.H.
S. Brooke Adams
Photo: FARM SHOW · Vol. 47, No. 3 (2023) · p. 32

“I created a tool to install a vent elbow into a snowplow hydraulic pump unit. The location is tight, and I needed a straight-on tool that would accept a 6-in. extension. I cut the head off an open-end 7/8-in. wrench.

Then I notched a 14 mm socket to accept the wrench head. I welded the two together and I had a great tool that has been used more than 100 times since I’m a snowplow tech. You could easily make different sizes if needed.”

Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.

Comments and votes

Have you tried this idea? Mark it helpful and share how it worked in your shop.