
“An old horseshoe and a barn door hinge made a great gate latch for our backyard fence. It was a simple fix that worked much better than the chain and snap I’d been using. There are a lot of horseshoe latch ideas on the internet, but I think this one is as simple as they come.
“Any size heavy-duty hinge will work, but the key is that it has only 270 degrees of travel. This way, when the horseshoe latch is lowered, it only goes a little past the halfway point.
“I figured out which side of the hinge plate would travel to that point and drilled two holes in the horseshoe to match the two holes in the hinge plate nearest the hinge pin.
“I bolted the two together temporarily, marked the excess hinge plate, cut it off and ground the edge smooth with an angle grinder. I also had to grind off a ridge on the horseshoe that prevented it from reaching a vertical position when mounted.
“Bolted back tight, it took only a few minutes to screw the new latch on the gate post. It works great, and I no longer have to deal with a snap that freezes up in the winter.”
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.