
Roger Gutschmidt has a money-saving tip for Constant Velocity (CV) joints. If the joint’s peg breaks off, repair it rather than replace it.
“Drive lines used prior to CV joints were more reliable and cheaper to buy and repair,” says Gutschmidt.
“If the peg in the joint breaks off, that usually means $1,500 out of the farmer’s pocket. I think they were made to fail, costing the customer money and downtime. They’re just another way to suck money out of customers.”
Gutschmidt’s solution to the problem is careful welding and reinforcement to reduce future problems.
“Usually, the piece that breaks off is about 1 in. long and 1/2 in. in diameter,” says Gutschmidt.
“It has a 3/16-in. hole in the center for grease.”
After grinding off the base of the peg to make room for his weld, Gutschmidt aligns the peg using a 3/16-in. drill bit in the center hole.
“The weld flows nicely, and when I finish, I touch up the base with a die grinder,” he says.
“I leave the drill bit in place but cut it off level with the top of the peg. It adds reinforcement, and the grease can still get through its spirals.”
Gutschmidt notes that the welding and reaming take only about 10 min.
“My customer put the U-joint crosses back together on his bale shredder,” he says.
“It was a cheap repair for the customer, and the shredder is still going strong.”
Contact: FARM SHOW Followup, Roger Gutschmidt, Gutschmidt Manufacturing, 202 Elm St. E., Box 311, Gackle, N.D. 58442 (ph 701-269-0537).
Reproduced from the published FARM SHOW entry. Prices, coupons, availability and contact details are historical, not current offers. Reader methods are not universal instructions: follow manufacturer guidance, proper supports and safety practices, and consult a qualified professional when needed.
Comments and votes
Have you tried this idea? Mark it helpful and share how it worked in your shop.