Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW

Welding & Fabrication

2159 shop tips and stories · page 17 of 36, newest issues first.

From the archive · Full text
Reader shop tip 1 of 3

Bruce Ashick

Individual tip 1 of 3 from this reader’s published contribution.
Bruce Ashick, Pembroke, Ont.

“The rubber on the crimp rollers in my Deere mower-conditioner started coming off in pieces. To solve the problem I removed the rollers, stripped off the rubber, and then welded straight 3/4-in. sq. rod on the rollers to…

Read the complete tip →
From the archive · Full text
Reader shop tip 3 of 3

Bruce Ashick

Individual tip 3 of 3 from this reader’s published contribution.
Bruce Ashick, Pembroke, Ont.

“I built my own arc air gouging tool from an old welding lead, some small steel tube, and air hose. It lets me burn carbon rod with air blowing on the end, which lets you remove old cracked…

Read the complete tip →
From the archive · Full text
Reader shop tip 1 of 2

Larry Genge

Individual tip 1 of 2 from this reader’s published contribution.
Larry Genge, Glovertown, Newfoundland; ph 709 533-2798, [email protected]

“I built this 20-ton press from scrap metal, using 10-in. channel iron for the side posts and 6-in. channel iron for the bed. I can use 3 different sizes of interchangeable dies with it, ranging from 3/4 to…

Read the complete tip →
From the archive · Full text
Reader shop tip 2 of 3

Dennis Jannusch

Individual tip 2 of 3 from this reader’s published contribution.
Dennis Jannusch, Zimmerman, Minn.

“A few years ago a main drive sprocket broke in half on my forage box. I solved the problem by clamping the sprocket’s two broken halves back onto the shaft with a hose clamp and welding it –…

Read the complete tip →
From the archive · Full text
Reader shop tip 1 of 2

Chad Travis

Individual tip 1 of 2 from this reader’s published contribution.
Chad Travis, Drasco, Ark.

“When re-sealing a paint can, take two layers of food-type cling wrap and place it over the top of the can. Then put the lid on. The plastic prevents metal-to-metal contact, making it easier to remove the lid…

Read the complete tip →
From the archive · Full text
Reader shop tip 2 of 3

Bill Reeks

Individual tip 2 of 3 from this reader’s published contribution.
Bill Reeks, Cromwell, Ky.

“To make it easier to adjust a floor jack, I welded a large washer to the adjustment screw that you normally turn with the handle. It’s a lot easier and quicker to use than trying to fit the…

Read the complete tip →