Practical ideas from FARM SHOW MagazineSubscribe · Free issue · Send us your shop tip
Subscribe to FARM SHOW

Welding & Fabrication

2159 shop tips and stories · page 31 of 36, newest issues first.

From the archive · Full text
Reader shop tip

Paul Horne

Paul Horne, 8950 Upper 240 th St. W., Lakeville, Minn. 55044 (ph 612 469-4229)

“I recently began marketing a hydraulic thrower control for Deere small square ejec-tion balers. These balers come with a steel rod that you have to manually rotate in order to adjust the bale’s throwing distance. To change the…

Read the complete tip →
From the archive · Full text
Reader shop tip

Rodman & Co., Inc.

Rodman & Co., Inc., 2823 N. San Fernando Blvd., Burbank, Calif. 91504 (ph 800 228-1806 or 818 846-9494; fax 9681)

“Our new ‘Nibbler’ sheet metal cutting head fits any electric, pneumatic or cordless drill with a speed range of 1,500 to 3,000 rpm’s. It cuts steel, brass, copper, aluminum, plastic, and fiberglass with no distortion, jagged edges, or…

Read the complete tip →
From the archive · Full text
Reader shop tip 2 of 2

Richard Cox

Individual tip 2 of 2 from this reader’s published contribution.
Richard Cox, Jacksonville, Ill.

The two men also came up with a handy high-speed sander-buffer for polishing steel shafts and also for rounding wood. It’s a high-speed emery blade mounted on an electric motor, mounted parallel to a small work table. They…

Read the complete tip →
From the archive · Full text
Reader shop tip 1 of 3

Herb Klassen

Individual tip 1 of 3 from this reader’s published contribution.
Herb Klassen, Kendall, Kan.

“I make 3-legged sawhorses out of steel pipe. The great thing about them is that they adjust to the contour of the ground. They’re made out of round steel pipe with angled braces at either end. Very handy.

Read the complete tip →
From the archive · Full text
Reader shop tip 3 of 4

Roger Bennett

Individual tip 3 of 4 from this reader’s published contribution.
Roger Bennett, Elkton, S. Dak.

Cutting steel is easier now that he mounted his chop saw on a table. To make the table, Bennett built an angle iron frame to fit around the base of the saw. The frame is welded to a…

Read the complete tip →
From the archive · Full text
Reader shop tip 1 of 2

Ken Schmitz

Individual tip 1 of 2 from this reader’s published contribution.
Ken Schmitz, Fond du Lac, Wis.

“I bought a used Westendorf loader at an auction. It had been mounted on a Massey tractor equipped with dual hydraulic outlets. However, I wanted to use it on a Massey Ferguson tractor that has only one hydraulic…

Read the complete tip →
From the archive · Full text
Reader shop tip 2 of 2

Dale Spoerl

Individual tip 2 of 2 from this reader’s published contribution.
Dale Spoerl, Elizabeth, Ill.

“I used scrap steel to make a 36-in. wide metal bender that lets me bend sheets of metal at a 90 degree angle. It’s equipped with a hinged handle on each side. I place the bender in a…

Read the complete tip →